Home >> HVAC Boosters >> Suncourt ThruWall Fan TW108

Suncourt ThruWall Fan TW108

Suncourt ThruWall Fan TW108
(0 reviews)  

Suncourt ThruWall Fan - Temperature Control Fan

Balance temperatures in adjoining rooms with the Suncourt ThruWall Fan. This room to room fan quietly and efficiently distributes cool air in the summer and warm air in the winter. The temperature control fan is available in white, but the Suncourt ThruWall Fan can be painted to suit any decor. The manufacturer does recommend using a quality, fast dry spray paint to customize the room to room fans.

Installation work must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.

The Suncourt ThruWall Fan TW108 does NOT have to be hard-wired into your electrical system, but comes equipped with a 10 foot grounded power cord. The power cord included with the temperature control fan must be plugged into a 110 Volt AC outlet. Each room to room fan has a 3-position rocker switch, which allows you to run the fan on high, low or off. The telescoping housing of the Suncourt ThruWall Fan allows it to be installed in wall frames 3.75 to 6.5 inches thick.

Important Note: Do not use this room to room fan in wet or damp locations (not for bathroom use). Do not install the ThruWall fan in a window or outside walls.

Suncourt ThruWall Fan Highlights:

  • Energy efficient and economically priced
  • Designed for complete airflow
  • 9.75 inch grille diameter
  • Install into frame of wall of adjoining rooms
  • Air exits the fan on the control side
  • Can be installed into the frame of walls 3.75 to 6.5 inches thick
  • Low voltage - 85 Watts (similar to medium sized light blub
  • Dual speed selection
  • 12 month limited manufacturer warranty
  • For wall use only. Cannot be used on floors

Important Information - Please read this PDF file with important information and installation instructions for the Suncourt ThruWall Fan TW108 before purchasing.

Room to Room Fan Installation Instructions

  1. Place the metal sleeve (without the grille attached) against the wall with the flanged edge facing you. Trace the pipe on the outside with a pencil to mark the cutout (Picture 1).
  2. Cut out the circular opening with a small drywall saw. Cut inside the pencil line (Picture 2).
  3. Project the edge of the cutout onto the inside of the other wall board in three places, approximately 120° apart. Use a small square or a piece of cardboard that has an exact 90° angle to mark the cutout points on the inside of the other wall. The two circular openings must be accurately aligned (Picture 3).
  4. Use a small sharp pin or very small drill bit (1/32" or smaller) to punch or drill these three marks to the outside of the other wall (Picture 4).
  5. Place the other sleeve, with grille attached, against the outside of the wall and center its location using the three markers that you have made, then trace the outside of the sleeve with a pencil. Cut the circular opening with a small drywall saw. Cut inside the pencil line (Picture 5).
  6. Insert the metal sleeve with the grille into the the cutout opening (fan output side) and snug the flange up against the wall material, making sure that power cord is hanging straight down.
  7. Insert the other metal sleeve into the cutout openings (fan suction side) and snug the flange up against the wall material.
  8. Position the unattached plastic grille over the metal sleeve that was just inserted so that the Suncourt logo is at the bottom and one of the mounting holes is in the top center. Mark the location of all 3 wall anchors. Make sure that the grille ribs are nicely square with the floor.
  9. Mark the position for the wall anchors on the grille.
  10. Remove the metal sleeve with grille attached and drill the holes on both sides of the wall for the anchors with a sharp 3/16" drill bit. Install wall anchors and after re-inserting metal sleeve with grille attached, screw the grilles down snugly (Picture 6). DO NOT OVER TIGHTEN

Suncourt ThruWall TW108 Installation Instructions

Need a room to room fan with more directional control of the aiflow? Check out our other HVAC Boosters.

SKU 29-0002#
Price: $83.49
Suncourt ThruWall Fan - Room to Room Fan
Suncourt ThruWall Fan - Temperature Control Fan Spec
Satin Nickel Wicker Floor Register
White Baseboard Return Grille - Triangular
White Round Register - 6 Inch
Steel Crest Custom Floor Register
Steel Toe Kick Return Grill - White or Golden Sand
14 Inch Round Ceiling Grille
TruAire 3 Way Floor Registers
TruAire Satin Nickel Baseboard Register
Double Deflection Spiral Duct Diffuser
There have been no reviews