Wall Clips Create Register Vent Covers for the Wall
Use wall clips with the Victorian, Contemporary, and Rockwell design floor registers and in just minutes you will have beautiful wall registers. One wall register vent cover can be created per pack of clips. The wall clips are coated with a dark protective finish making them both durable and discreet. Wall clips measure 2 1/2" and will extend 1 1/8" past the register vent cover into the duct work. The only tool required to install wall clips on your register vent covers is a Phillips head screw driver. Do not use wall register clips to mount register vent covers to ceiling.
Metal Vent Cover Clip Highlights
- Extends 1 1/8" past register vent covers, total length is 2 1/2"
- Use with Victorian, Contemporary, and Rockwell designs
- Four wall clips per pack, enough for one register
- Not for ceiling installation
How to Create Register Vent Covers for the Wall:
- Set register vent cover face down on smooth, clean surface
- Remove screw from side using a #2 Philips head screwdriver
- Attach wall clips to damper using screws from side and tighten
- Repeat for other three screws
- Insert register into duct opening on wall
Tip: These wall clips are only for use with the Victorian, Contemporary, and Rockwell designs. They will not work with any other registers.
Add a few sets of wall register clips to your order and have matching wall and floor registers! |
